"WarShrike" (warshrike)
01/31/2016 at 20:55 • Filed to: None
4
0|
"WarShrike" (warshrike)
01/31/2016 at 20:55 • Filed to: None | 4
| 0 |
Couldn’t find a twist in oil cap that would fit the valve covers that also had a vent that I could route to a catch can. So I made one instead.
Drilled out the rivet that held the stamped metal oil cap together, then used a step drill to open it all up to let the -10AN fitting slip through.
Test fit worked great up top!
But DeezNutz were too big.
A little bit of tender time with the dremel to knock off the high spots, I made it into a press-fit setup.
More catch can progress soon! Until then, practice safe modding.
